标签:900F AC CM CI module ABB CPU
5.3 Coupler bus slots
耦合器总线插槽
The C1 to C2 coupler bus slots serve for connecting the CI/CM communication interfaces to the CPU module. When configuring the AC 900F controller and integrating a CI/CM module, the bottom module part must be plugged in first. Then press the top module part backwards until it locks in place at the top of the slot. To check whether the module is securely locked, try to pull it out after it is locked
C1 到 C2 耦合器总线插槽用于连接到CPU 模块的CI/CM通信接口。当配置AC 900F控制器和集成CI/CM模板时,必须先插入底板。然后向后模块顶部部分,直到它在插槽顶部锁住。为检查是否锁住,可以尝试在锁住后拔出(看是否能拔出来)
A TA dummy coupler is installed and removed from the C1 to C4 slots as described for a communication interface
按照通讯接口的(安装和拆除)描述,安装和拆除空插槽保护盖板。
The module change during operation is described in Section 8, Service
在线模块更改(方法)在第八章有描述。
5.4 PM housing front
The central area of the housing front of the CPU module is equipped with a removable cover. This cover can be taken off without any tools and be replaced by a TD display unit.
CPU模板前面中央区域配置可拆除的盖子。取掉此盖板无需任何工具,并用TD显示单元替代。
5.5 Dimensional drawings
图纸尺寸
Note: All dimensions are indicated in mm.
注意:所有的尺寸单位是毫米
5.5.1 Dimensional drawings of the PM CPU module
CPU模板的图纸尺寸
Front view
前视图
Lateral view
侧视图
标签:900F,AC,CM,CI,module,ABB,CPU 来源: https://www.cnblogs.com/fishingsriver/p/15151845.html
本站声明: 1. iCode9 技术分享网(下文简称本站)提供的所有内容,仅供技术学习、探讨和分享; 2. 关于本站的所有留言、评论、转载及引用,纯属内容发起人的个人观点,与本站观点和立场无关; 3. 关于本站的所有言论和文字,纯属内容发起人的个人观点,与本站观点和立场无关; 4. 本站文章均是网友提供,不完全保证技术分享内容的完整性、准确性、时效性、风险性和版权归属;如您发现该文章侵犯了您的权益,可联系我们第一时间进行删除; 5. 本站为非盈利性的个人网站,所有内容不会用来进行牟利,也不会利用任何形式的广告来间接获益,纯粹是为了广大技术爱好者提供技术内容和技术思想的分享性交流网站。